Final craft foam prototype; from trying it on I was able to see the size of the masks beak and eyeholes and check the proportioning's. The beak was actually a lot larger than I thought it would be and the mask fit quite well over all. However, it was a little tight in places due to the new bottom jaw panel so I fixed this by resizing this piece but slitting it open a few centimeters. This lets me know that in my next prototype I will have to add in these extra centimeters to the pattern piece.
I also wrote notes onto this prototype itself, such as lines around the eyes and notes around the chin indicating the fact that the sizes must be changed.
No comments:
Post a Comment